Ncs314-6 v3.3 tubes lighting up erratically and function does nothing.

Nixie Tubes Clocks | Shields for Arduino Clocks | Raspberry Pi HAT Nixie Clocks | DIY KITs for Nixie Clocks | Cases for Nixie Clocks | Nixie Tubes | RF Units | Assembled Boards | Bare PCBs | Components | Spare Parts | Circuits | Firmwares… › Forums › Questions and answers about PRODUCTS › Ncs314-6 v3.3 tubes lighting up erratically and function does nothing.

This topic contains 0 replies, has 1 voice, and was last updated by  ehoitink1 5 years, 1 month ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 23.01.2020 at 17:11 #26063

    ehoitink1
    Participant

    Hello , I got a ncs314-6 v3.3 board for Xmas with the tubes already soldered. I purchased the acrylic case and the audrino mega board and your power cord . When I plug it in it seems like only half the colors light up and the number test on the bulbs is very cloudy. Then it proceeds to basically shut off each light on its own like a candle burning out. None of the buttons do anything but beep. Do I need to install a firmware still or what else do I have to do to make this a functioning clock . Thank you for your response.

  • Author
    Posts
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.