Power Supply died for IN-14 Nixie Arduino Shield / Pi

Nixie Tubes Clocks | Shields for Arduino Clocks | Raspberry Pi HAT Nixie Clocks | DIY KITs for Nixie Clocks | Cases for Nixie Clocks | Nixie Tubes | RF Units | Assembled Boards | Bare PCBs | Components | Spare Parts | Circuits | Firmwares… › Forums › Questions and answers about PRODUCTS › Power Supply died for IN-14 Nixie Arduino Shield / Pi

This topic contains 0 replies, has 1 voice, and was last updated by  dt 3 days, 18 hours ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 30.05.2025 at 01:36 #61832

    dt
    Participant

    I am going to buy another Power supply locally… but just wanted to ask before I plug in a new P/S.

    Is there anything on the Shield board that could have caused the P/S to die ?

    Is there a Fuse on the Shield that could have blown?

    Just want to see if there is anything I need to take a closer look on the Shield at before plugging a new power supply into the Shield.

    Any recommendations appreciated.

    Thank you,
    -dt

  • Author
    Posts
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.