Time doesn't save after power off

Nixie Tubes Clocks | Shields for Arduino Clocks | Raspberry Pi HAT Nixie Clocks | DIY KITs for Nixie Clocks | Cases for Nixie Clocks | Nixie Tubes | RF Units | Assembled Boards | Bare PCBs | Components | Spare Parts | Circuits | Firmwares… › Forums › Questions and answers about PRODUCTS › Time doesn't save after power off

This topic contains 0 replies, has 1 voice, and was last updated by  nickwh555 3 years, 10 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 28.01.2021 at 14:08 #37092

    nickwh555
    Participant

    I am using a MCU NCM109 Control Board & NCT412 Tubes Board.
    When I set the time / date it works fine until it is powered off and then restarted. It always starts showing the time 17:19:30 and needs the time adjusted. The 3V power backup seems to be working, and I switched the backlight LEDs off and these don’t reset to the default settings when restarted so it has saved some settings.

  • Author
    Posts
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.