Use of SPI1 connector on bottom of NCS314 Shield?

Nixie Tubes Clocks | Shields for Arduino Clocks | Raspberry Pi HAT Nixie Clocks | DIY KITs for Nixie Clocks | Cases for Nixie Clocks | Nixie Tubes | RF Units | Assembled Boards | Bare PCBs | Components | Spare Parts | Circuits | Firmwares… › Forums › Questions and answers about PRODUCTS › Use of SPI1 connector on bottom of NCS314 Shield?

Tagged: 

This topic contains 1 reply, has 2 voices, and was last updated by  Doridian 6 years, 3 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 14.07.2018 at 21:33 #7756

    sutton57
    Participant

    There’s a male connector on the bottom of the NCS314 labelled “SPI1” that doesn’t mate with any connector on the Arduino Mega 2560. Is this a port you use for testing that isn’t needed for normal use?

    04.09.2018 at 15:01 #9810

    Doridian
    Participant

    According to the schematics, SPI1 is wired to MOSI and SCK of the Arduino with the two remaining pins not connected.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.