Today is your last chance to get our discount, use code 5off for 5% off your order
for orders over 500$ you can contact us to get bigger discount

Soroush Lohrasb

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
17.11.2020 at 02:15 in reply to: NCS314 v2.2 tubes do not index – help appreciated #35741

Soroush Lohrasb
Participant

I have removed the U1 and U2 Chips and have ordered new ones which I will solder on very carefully. It was difficult to tell if they were bridged so I decided upon replacement.

I will post once i test after putting the new chips on. I should get them next week on the 23rd

16.11.2020 at 04:38 in reply to: NCS314 v2.2 tubes do not index – help appreciated #35736

Soroush Lohrasb
Participant

Yes it does. The LEDs cycle through the full range of colors too. It’s just the tubes having all the digits illuminated. That is on all 6 tubes

16.11.2020 at 02:13 in reply to: NCS314 v2.2 tubes do not index – help appreciated #35734

Soroush Lohrasb
Participant

Ok. I will check. Also, is there a version 2.2 firmware or is it just the v2.0 firmware?

15.11.2020 at 06:44 in reply to: NCS314 v2.2 tubes do not index – help appreciated #35725

Soroush Lohrasb
Participant

I have loaded firmware 2.0 there is no v2.2 in the repository on Github. I have closely looked at U1 and U2 and there isn’t any bridging. Also bridging would only cause this problem to all of the tubes if I had many bridged pins.

14.11.2020 at 00:35 in reply to: NCS314 v2.2 tubes do not index – help appreciated #35722

Soroush Lohrasb
Participant

I have the exact same problem
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)