Board NCS314-6 v.3.4 w/Raspberry Pi adapter

Nixie Tubes Clocks | Shields for Arduino Clocks | Raspberry Pi HAT Nixie Clocks | DIY KITs for Nixie Clocks | Cases for Nixie Clocks | Nixie Tubes | RF Units | Assembled Boards | Bare PCBs | Components | Spare Parts | Circuits | Firmwares… › Forums › Questions and answers about PRODUCTS › Board NCS314-6 v.3.4 w/Raspberry Pi adapter

This topic contains 0 replies, has 1 voice, and was last updated by  David Reynolds 6 months, 3 weeks ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 11.10.2023 at 23:55 #45996

    David Reynolds
    Participant

    I recently purchased the ncs314-6 v.3.4 Arduino shield with the Raspberry Pi Astrpa v.2.1 adapter. After setting up the Pi per the instructions, the tubes do not display anything other than a quick flash once powered on.

    In reading others posts, I tried a larger power supply, which did not change anything. I then resurrected an old Arduino Uno and that worked just fine and the clock worked as intended. Are there any suggestions for troubleshooting the Arduino – Pi adapter board, or ways to verify that the software has been installed correctly? Thanks!

  • Author
    Posts
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.