NCS314 Shield – L1 getting VERY hot

Nixie Tubes Clocks | Shields for Arduino Clocks | Raspberry Pi HAT Nixie Clocks | DIY KITs for Nixie Clocks | Cases for Nixie Clocks | Nixie Tubes | RF Units | Assembled Boards | Bare PCBs | Components | Spare Parts | Circuits | Firmwares… › Forums › Questions and answers about PRODUCTS › NCS314 Shield – L1 getting VERY hot

Tagged: 

This topic contains 1 reply, has 2 voices, and was last updated by  Gra Afch 5 years, 6 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 15.06.2019 at 17:52 #20641

    buildxyz
    Participant

    Hi all,

    I have just completed two of these awesome kits and I’m having an overheating issue with both boards. The boards both work 100% with no other issues.

    My problem is with the high voltage circuitry, L1 get very hot. Q1 and L2 get warm but L1 is getting very hot to point were I’m nervous to leave it on all night without burning down my house!

    TP4 is fully adjustable, I have tried setting it a 170/180/190 Volts.

    I would really like to know if these components get warm/hot for anyone else?

    Attached is an imagery of the circuit in question, in the event I place a component wrong on both my boards.

    Board photo

    17.06.2019 at 13:38 #20644

    Gra Afch
    Keymaster

    Try to check resistors R1, R2, R3, R4, R5, R6.
    They should be 24 kOhm (marked as 243).

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.