NCS314 v2.2 IN-14 Diodes and Temp Sensor

Nixie Tubes Clocks | Shields for Arduino Clocks | Raspberry Pi HAT Nixie Clocks | DIY KITs for Nixie Clocks | Cases for Nixie Clocks | Nixie Tubes | RF Units | Assembled Boards | Bare PCBs | Components | Spare Parts | Circuits | Firmwares… › Forums › Questions and answers about PRODUCTS › NCS314 v2.2 IN-14 Diodes and Temp Sensor

Tagged: 

This topic contains 0 replies, has 1 voice, and was last updated by  JoshGad 4 years, 1 month ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 22.03.2020 at 22:53 #27858

    JoshGad
    Participant

    Hi, is the D11 diode necessary? It wasn’t in my kit. R35 and R0 are connected though. Also, how should I wire the temperature sensor? I have the red, black and yellow cable, the sensor and the clear plastic tube. I already soldered the white connector to the board.

  • Author
    Posts
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.