[dzing3rParticipant]

Ha that is fair . Maybe that could be arranged…

Would be neat to see someone make a wiki or information repository compiled somewhere about these things. Definitely have to go back through everything if you want to make changes as the methodology of design isn’t really easily seen just in the source. It would have been nice to get really detailed comments in the code but I suppose it’s at least good they gave a few pointers here and there.

[dzing3rParticipant]

Looks good. Bonus points if you fork the 8C version and add your changes to that codebase. I don’t use GH anymore but use GL instead.

I have been meaning to add things like DST and comment what I can figure out as I dig through it but have not yet had time.

[dzing3rParticipant]

I didn’t even get a response when I inquired. I just went around them and bought new. Not worth my time fighting with them about it. I guess for the money I expected a bit more, but that is fine.

You are correct. The proper current must be maintained and I suppose it’s worth doing the math to calculate and verify. I have considered doing my own firmware fork of their messy codebase, but have not had time yet.

[dzing3rParticipant]

Since I posted that I have lost another tube. I too believe the gas leaked out at the bottom. Difficult to tell date code on these, since that has all been rubbed off. Mine were definitely used tubes. I’m pretty sure that the problem isn’t the resistor on the board, since I have just had two random tube failures and the resistor is the same on both of those tubes.

I bought NOS tubes and replaced them and have not have problems since.

[dzing3rParticipant]

Sorry just seeing this now as I’m browsing the site. Did you figure things out or do you still need help?

[Author]

Posts